SLIM-LINE METAL LOCKING CONNECTORS

FRONT PANEL MOUNT

1. SL18 RECEPTACLES Front of Panel Mount SL183FS (typical)
2. Cable Clamp SL04

Front of panel mount; 2 through 5 pins (male) or 2 through 5 contacts (female). Also 2-, 3- and 4-contact insert with 3 shunted (N.C.) contacts. Mounting locknut (Part Number SL01), lockwasher (Part Number SL02), and flat washer (Part Number SL03) supplied.

SL MALE RECEPTACLES

Part Number	Pins	Pin Arrangements
¤SL182M	2	1
¤SL183M	3	2
¤SL184M	4	3
¤SL185M	5	4

SL MALE RECEPTACLES

Part Number	Contacts	Pin Arrangements
¤SL182F	2	A
¤SL183F	3	B
¤SL184F	4	C
¤SL185F	5	D

INSTALLING CABLE CLAMP ON INSERT

To install cable clamp on any insert:

1. Position insert approximately as shown in the diagram.

2. Hold clamp at approximately 30° angle (as shown). Place tip of clamp center finger into slot under molded ring "A". Note position of notch on insert in relation to slot.

3. Press center finger forward into slot and reduce angle of clamp until clamp shoulders seat just ahead of molded barrier on rear of insert "B".

click here to download a schematic drawing
(you will need to have Adobe Acrobat installed on your system to do this)

To search a category please click on the corresponding button:

| Connectors | Jacks and Plugs |
| Patch Panels, Patch Kits & Jackfields | Cable Assemblies and Patch Cords | Switches |

All products shown are covered by Switchcraft's limited lifetime warranty.